C 1500 Suburban 2WD V8-4.8L VIN V (2002)
4. Raise the rear axle, using the adjustable jackstands.
5. Install the lower bolts and nuts to the rear shock absorbers.
-
Tighten the rear bolts to 95 Nm (70 ft. lbs.).
6. Remove the adjustable jack stands from under the rear axle.
7. Install the vent hose swivel clip to the rear brake crossover pipe.
8. Install the rear axle vent hose to the rear axle, if necessary.
9. If servicing a vehicle, equipped with RPO Z55, install the left and right sensor link rods to the sensors. Using J 38185 install the link rods to the
ball studs on the sensor levers.
10. Connect the chassis harness to the following electrical connectors:
-
Electronic suspension rear position sensor (1)
-
Rear shock (2)
11. Install the spare tire.
