Chevrolet Workshop Manuals
C 1500 Truck 2WD V6-4.3L VIN X (2003)
Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Accessory Delay Module > Component Information > Diagrams > Diagram Information and Instructions > Page 25
The following procedure determines the difference in voltage potential between 2 points.
1. Set the rotary dial of the DMM to the V (DC) position.
Probing Electrical Connectors
PROBING ELECTRICAL CONNECTORS
IMPORTANT: Always be sure to reinstall the connector position assurance (CPA) and terminal position assurance (TPA) when reconnecting
NOTE: Do not insert test equipment probes into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A
|[PREV PAGE] [NEXT PAGE]|