Chevrolet Workshop Manuals
C 1500 Truck 2WD V6-4.3L VIN X (2003)
Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Accessory Delay Module > Component Information > Diagrams > Diagram Information and Instructions > Page 30
J 34142-B 12 V Unpowered Test Lamp
NOTE: Refer to Test Probe Notice in Service Precautions.
A test lamp can simply and quickly test a low impedance circuit for voltage.
The J 34142-B is Micro-Pack compatible and comprised of a 12-volt light bulb with an attached pair of leads.
To properly operate this tool use the following procedure.
1. Attach one lead to ground.
Using Connector Test Adapters
USING CONNECTOR TEST ADAPTERS
NOTE: Do not insert test equipment probes into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A
Using Fused Jumper Wires
USING FUSED JUMPER WIRES
J 36169-A Fused Jumper Wire
IMPORTANT: A fused jumper may not protect solid state components from being damaged.
The J 36169-A includes small clamp connectors that provide adaptation to most connectors without damage. This fused jumper wire is supplied with a
Connector Position Assurance Locks
CONNECTOR POSITION ASSURANCE LOCKS
The connector position assurance (CPA) is a small plastic insert that fits through the locking tabs of all the SIR system electrical connectors. The CPA
Terminal Position Assurance Locks
TERMINAL POSITION ASSURANCE LOCKS
The terminal position assurance (TPA) insert resembles the plastic combs used in the control module connectors. The TPA keeps the terminal securely
Push to Seat Connectors
PUSH TO SEAT CONNECTORS
Follow the steps below in order to repair push to seat connectors.
1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
|[PREV PAGE] [NEXT PAGE]|