Chevrolet Workshop Manuals
C 1500 Truck 2WD V6-4.3L VIN X (2003)
Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Accessory Delay Module > Component Information > Diagrams > Diagram Information and Instructions > Page 37
SIR/SRS Connector (Plastic Body And Terminal Metal Pin) Repair
The terminals in the SIR/SRS system are made of a special metal. This metal provides the necessary contact integrity for the sensitive, low energy
If the individual terminals are damaged on the sensing and diagnostic module (SDM) harness connector, use 1 of the following 2 components in order
The SDM harness connector pigtail assembly
The SDM harness connector replacement kit
If the individual terminals are damaged on any other SIR/SRS connection, use the appropriate connector repair assembly pack in order to replace the
SIR/SRS Wire Pigtail Repair
IMPORTANT: Do not make wire, connector, or terminal repairs on components with wire pigtails.
A wire pigtail is a wire or wires attached directly to the device (not by a connector). If a wiring pigtail is damaged, you must replace the entire
SIR/SRS Wire Repair
IMPORTANT: Refer to Wiring Repairs in order to determine the correct wire size for the circuit you are repairing. You must obtain this information
If any wire except the pigtail is damaged, repair the wire by splicing in a new section of wire of the same gage size (0.5 mm, 0.8 mm, 1.0 mm etc.).
1. Open the harness by removing any tape:
Use a sewing seam ripper (available from sewing supply stores) in order to cut open the harness in order to avoid wire insulation damage.
Use the crimp and sealed splice sleeves on all types of insulation except tefzel and coaxial.
Do not use the crimp and sealed splice sleeve to form a splice with more than 2 wires coming together.
IMPORTANT: You must perform the following procedures in the listed order. Repeat the procedure if any wire strands are damaged. You must
2. Cut as little wire off the harness as possible. You may need the extra length of wire in order to change the location of a splice. Adjust splice
locations so that each splice is at least 40 mm (1.5 in) away from the other splices, harness branches, or connectors.
3. Strip the insulation:
When adding a length of wire to the existing harness, use the same size wire as the original wire.
Perform one of the following items in order to find the correct wire size:
|[PREV PAGE] [NEXT PAGE]|