C 1500 Truck 2WD V6-4.3L VIN X (2003)
Windshield Moulding / Trim: Service and Repair
Stationary Window Reveal Molding Repair
Stationary Window Reveal Molding Repair
Removal Procedure
Caution: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.
Important: The window reveal molding fills the cavity between the body and window. If the reveal molding is stretched or damaged, it
cannot be reused and it must be replaced.
1. Lift up on the loose area of the reveal molding.
2. Clean the top edge of the window surface and the reveal molding with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened
lint-free cloth.
3. If the reveal molding cannot be reused, refer to Stationary Window Reveal Molding Repair.
Installation Procedure
Caution: Refer to Window Retention Caution in Service Precautions.
1. Verify all primers and urethane adhesive are within expiration dates.
Important: Use care when applying the prep, clear #1, to the window. This primer dries almost instantly, and may stain the viewing area
of the window if not applied evenly.
2. Use a new dauber in order to apply glass prep, clear #1, to the channel area approximately 13 mm (1/2 in) to the upper edge of the window.
3. Wipe the glass primed area immediately with a clean lint-free cloth.
4. Shake the glass primer, black #2, for at least 1 minute.
5. Use a new dauber in order to apply glass primer, black #2, to the top edge of the window.
6. Apply a small bead of urethane adhesive (2) between the window (1) and the pinch-weld.
