C 1500 Truck 2WD V8-454 7.4L (1990)
Removing The Pulley Bearing
^
Hold J 33020 in place and tighten the puller screw against J 33023-A puller pilot to remove the pulley (5).
4. Pulley bearing (4) from the pulley (5) using J 9398-A and J 29886.
^
Remove the forcing screw from J 33020 and with the puller tangs still in place in the pulley slots, turn the assembly upside down onto a flat
surface.
^
When removing the old pulley bearing (5) allow the staking to remain, then file away the old staked metal for proper fit when installing a new
bearing (5) in the pulley bore.
Install or Connect
Tools Required:
J 6083 Snap Ring Pliers
J 8433-1 Puller Bar
J 9481-A Pulley Bearing Installer
J 33017 Pulley and Bearing Assembly Installer
J 33019 Bearing Staking Tool (with staking pin and retaining band)
J 33023-A Puller Pilot
J 33026 Compressor Holding Fixture
J 21352-A Compressor Support Block
1. Pulley (5) on J 21352-A.
NOTICE: Do not support the rotor by resting the pulley rim on a fiat surface during bearing installation or the rotor lace will be bent.