C 1500 Truck 2WD V8-454 7.4L (1990)
Installing The Seal
1. New O-ring seal, dipped in 525 refrigerant oil, onto J 33011.
2. O-ring completely down on the shaft until it bottoms.
Important
^
The seal seat and the seal lip must be free of lint or dirt.
3. Lip seal to J 23128-A.
^
The printed/stamped side of the seal must be engaged with the knurled tangs of J 23128-A so that the flared out side of the seal is facing the
compressor.
NOTICE: Handling the care of seal protector is important. If the seal protector is nicked or the bottom flared, the new seal may be damaged during
installation.
4. J 34614 on the shaft.
5. Lip seal. Disengage installer by turning it counter-clockwise.
6. Retainer ring, flat side against the seal seat using J 5403. Use J 33011 to seat the retainer in its groove.