C 1500 Truck 2WD V8-454 7.4L (1990)
FIGURE 15
-
The vehicle must be stable and should not rock on floor stands.
-
If vehicle is equipped with aluminum wheels it may be necessary to first remove wheel.
Check the ball joints for vertical looseness:
-
With vehicle on the jack stands, place dial indicator against spindle to show vertical movement (Figure 15).
-
Pry between lower control arm and outer race while reading dial indicator. This will show vertical looseness in ball joints (Figure 15).
-
If dial indicator reading is more than 1 mm (0.040 inch), replace ball joint.
NOTICE:
Do not pry between lower arm and drive axle seal or in such a manner that ball joint seal is contacted. Damage to the seal will result (4WD).
1990 C AND K MODEL UPPER
-
Be sure vehicle rests on a level surface.
Figure 14
BALL JOINT WEAR CHECK (1990 ONLY) - Con't
1990 C AND K MODEL UPPER (Con't)