C 1500 Truck 2WD V8-5.3L VIN T (1999)
6. Lower the vehicle.
Brake Rotor Replacement-Rear
REMOVAL PROCEDURE
You can remove the brake rotor without separating the caliper from the mounting bracket.
1. Release the parking brake.
2. Remove 2/3 of the brake fluid from the master cylinder.
3. Raise and support the vehicle.
4. Remove the tire and wheel assembly.
5. Remove the caliper and mounting bracket as an assembly.
6. Hang the caliper and mounting bracket assembly from the suspension using mechanics wire.
7. Remove the rotor. Slowly turn the rotor while pulling the rotor away from the axle. (15 series).
8. Remove the rotor. Slowly turn the rotor while pulling the rotor away from the axle. (25 series).
INSTALLATION PROCEDURE
1. Clean all rust and contaminants from the both sides of the rotor and the hub flange.