C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
5. Remove old O-ring seal from the switch cavity using J 9553-01 O-ring removal tool.
If existing control switch is reinstalled in the compressor, a new O-ring seal must be used and preferably a new retainer ring should also be used. A new
switch kit has the O-ring and retainer ring included.
Install or Connect
1. Check switch cavity and O-ring groove in the rear head for din or foreign material and clean as necessary. Install a new O-ring coated with clean
refrigerant oil into groove in switch cavity.
2. Lubricate the control switch housing with clean refrigerant oil and carefully insert switch into switch cavity until switch bottoms in cavity.
3. Using J 9533-1 snap ring pliers install switch retaining ring with high point of curved sides adjacent to switch housing. Be sure retaining ring is
properly seated in switch cavity retaining groove. Leak test according to bench test procedure.
