C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
3.2. Use a seal installation tool or a flat block in order to press the seal down flush with the hub.
3.3. Seat the outer bearing and the cup.
Important: Do not scuff the spindle threads.
4. Install the hub/rotor to the spindle.
5. Install the outer bearing to the hub/rotor.
6. Install the washer.
Important: Adjust the wheel bearings.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
7. Install the nut.
Tighten
7.1. Tighten the nut to 16 Nm (12 ft. lbs.), while turning the wheel assembly forward by hand.
7.2. Apply grease to the outboard side of the outer bearing.
8. Install the brake caliper.
