C 1500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Testing The Rotor Field Windings
Testing The Starter For Grounds
Installing The Slip Ring End Bearing
INSTALL OR CONNECT
1. Drive end bearing into the frame.
-
Press against the outer race to press the bearing into place.
2. Retainer with three screws.
NOTICE: On models with a slip ring end ball bearing on the rotor shaft, this bearing must be replaced with a new bearing any time the two
halves of the generator are separated. If not replaced, the bearing may bind and fail due to distortion of its outer tolerance rings. This does not
apply to roller-type slip ring end frame bearings.
