C 2500 Suburban 2WD V8-6.0L VIN U (2002)
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
^
Remove all traces of the original adhesive patch.
^
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
^
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the caliper bracket mounting bolts (2).
^
For vehicles equipped with JC5/JH5 brake systems, tighten the caliper bracket mounting bolts to 200 Nm (148 ft. lbs.).
^
For vehicles equipped with JH6 brake systems, tighten the caliper bracket mounting bolts to 165 Nm (122 ft. lbs.).
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads to the brake caliper bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
