C 2500 Suburban 2WD V8-6.0L VIN U (2002)
Brake Fluid Pressure Sensor/Switch: Service and Repair
Pressure Accumulator Switch Replacement
Pressure Accumulator Switch Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the bolts (2) that secure the Brake Pressure Modulator Valve (BPMV) (1) to the mounting bracket (3).
3. Disconnect the electrical connector from the pressure accumulator switch.
4. Position the BPMV to be able to remove the pressure accumulator switch.
5. Remove the pressure accumulator switch from the BPMV.
Installation Procedure