C 2500 Suburban 2WD V8-6.0L VIN U (2002)
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor link from the ball stud.
5. Remove the bolts.
6. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the bolts.
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Connect the sensor link to the ball stud.
4. Connect the sensor harness connector to the vehicle harness connector.
