C 2500 Suburban 2WD V8-6.0L VIN U (2002)
1. Install the relay rod (9) to the vehicle.
2. Install the relay rod (9) to the pitman arm ball stud (2).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the relay rod (9) to the idler arm ball stud (1). Ensure the seal is on the stud.
4. Install the J29193 or the J29194.
5. Tighten the steering linkage installer in order to seat the tapers.
Tighten the steering linkage installer to 54 Nm (40 ft. lbs.).
6. Remove the J29193 or the J29194.
7. Install the new pitman arm prevailing torque nut.
8. Install the new idler arm prevailing torque nut.
Tighten the nuts to 62 Nm (46 ft. lbs.).
9. Install the tie rod ends.
10. Install the steering dampner to the relay rod, if equipped.
11. Install the engine protection shield, if equipped.
12. Lower the vehicle.
13. Check the wheel alignment.
