C 2500 Suburban 2WD V8-6.0L VIN U (2002)
Power Steering Pump: Service and Repair
Power Steering Reservoir Replacement - Off Vehicle
Power Steering Reservoir Replacement - Off Vehicle
Disassembly Procedure
1. Drain the power steering fluid from the power steering pump.
2. Remove the pump mounting studs (2).
3. Remove the connector and fitting assembly (5). To remove the variable assist steering actuator (3) and retaining ring (4); refer to Power Steering
Pump Flow Control Valve Actuator Replacement - On Vehicle.
4. Remove the O-ring seal (6) from the connector and fitting assembly (4).
5. If replacement is required, remove the control valve assembly and the flow control spring from the pump housing assembly.
6. Remove the reservoir assembly (1) from the pump housing assembly (2).
7. Remove the O-ring seals (1) (4).
8. Remove the magnet (3).
9. Clean the magnet (3).