C 2500 Suburban 2WD V8-8.1L VIN G (2001)
1. Install the brake hose. Do not twist the hose when installing the hose.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake hose mounting bolt and new compression washers at the caliper.
^
Tighten the bolt to 45 Nm (33 ft. lbs.).
3. Install the brake hose bolt and the bracket to the steering knuckle.
^
Tighten the bolt to 9 Nm (80 inch lbs.).
4. Install the brake hose bolt and the bracket to the upper control arm.
^
Tighten the bolt to 9 Nm (80 inch lbs.).
5. Install the brake hose bolt to the frame.
^
Tighten the bolt to 12 Nm (106 inch lbs.).
6. Install the brake hose retaining clip.
7. Connect the brake pipe.
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
8. Bleed the brake system.
9. Install the tire and wheel assembly.
10. Remove the safety stands.
11. Lower the vehicle.