C 2500 Suburban 2WD V8-8.1L VIN G (2001)
Notice:
^
DO NOT drive the selector lever onto the selector shaft.
^
DO NOT use an impact wrench in order to tighten the selector lever nut. Hold the lever with a wrench while tightening the nut.
^
Failure to follow these instructions may result in transmission damage.
8. Reinstall shift lever (2). Install nut (3), by hand, on the end of selector shaft (4). Use a wrench (1) to keep the shift lever from rotating.
^
Tighten nut (3) to 24 Nm (18 ft. lbs.).
9. Reconnect the shift selector linkage/cable to the shift lever (2).
10. Connect the external wiring harness connector to the PNP switch.