C 2500 Suburban 2WD V8-8.1L VIN G (2001)
Suspension Strut / Shock Absorber: Service and Repair
Rear Shock Absorber
Shock Absorber Replacement
Shock Absorber Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle.
3. Disconnect the Real Time Damping (RTD) electrical connector at the pigtail connector left side only (if equipped).
4. Disconnect the RTD electrical connector at the top of the right side shock (if equipped).
5. Disconnect the RTD sensor (if equipped). Refer to Rear Position Sensor Replacement - Electronic Suspension in Real Time Damping (RTD).
6. Remove the upper shock absorber nut and the bolt.
7. Remove the lower shock absorber nut and the bolt.
8. Remove the shock absorber.
Installation Procedure