C 2500 Truck 2WD V8-305 5.0L VIN M SFI (1997)
WSS Harness Routing
WSS Harness Routing
Remove or Disconnect
1. Tire and wheel.
2. Brake caliper.
3. Hub and rotor.
4. Wheel speed sensor electrical connector.
5
Wheel speed sensor harness clip rivets.
^
Use a 3/16 inch drill.
6. Clips from wheel speed sensor wire.
^
Save clips for new wheel speed sensor.
7. Wheel speed sensor mounting bolts and nut.
8. Splash shield mounting bolts.
9
Wheel speed sensor and splash shield.
10. Splash shield gasket.
Install or Connect
CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. General Motors will call out those fasteners that require a replacement after removal. General Motors will also call out the fasteners that
require thread lockers or thread sealant. Unless otherwise specified, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on
threaded fasteners or fastener joint Interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage
the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid
damage to parts and systems.
1. Splash shield gasket.
2. Wheel speed sensor and splash shield.
3. Splash shield mounting bolts.
^
Torque splash shield bolts to 16 Nm (12 lb. ft.).
4. Wheel speed sensor mounting bolts and nut.
^
Torque Wheel speed sensor mounting bolts to 26 Nm (19 lb. ft.).
5. Harness clips on wheel speed sensor wire.
^
Locate clips at paint dots on wire.
6. Harness clips and 3/16 inch rivets.
7. Wheel speed sensor electrical connector.
8. Hub and rotor.
9. Brake caliper.
10. Tire and wheel.
