C 2500 Truck 2WD V8-393 6.5L DSL Turbo VIN S (1995)
Tighten
-
Bolts to 27 Nm (20 lbs. ft.).
2. Pulley to the pump using tool J 25033-B until the pulley is flush with the end of the shaft.
CAUTION: Do not tap the pulley back onto the pump shaft. The pump could be damaged.
INSTALL OR CONNECT
1. Vacuum pump (1) to the bracket (10) with bolts (11).
Tighten
Bolts to 27 Nm (20 lbs. ft.).
2. Bracket and the pump to the engine with bolts (12) and nut.
Tighten
-
Bolts to 40 Nm (30 lbs. ft).
3. Electrical connector to the compressor clutch.
4. Drive belt.