C 2500 Truck 2WD V8-454 7.4L (1988)
2.
Clean inner fender wells using a coarse brush, water, prep sol (DuPont P/N 39295 or equivalent) and mineral spirits as needed to assure a clean
inner fender surface (figure 1).
3.
Shake the water borne protectant well before using.
SPRAY PROCESS
1.
Attach the spray gun directly to the protectant container.
2.
Hold the spray gun (J38337) with the nozzle at a 45 degree angle and 10 to 12 inches from the surface.
3.
Spray at a 60 to 80 psi, and spray only the horizontal surface area above the tire (figure 1). Pressures above 80 psi will cause an excessive splatter
pattern.