chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Binding Lock Cylinders|Page 11980 > < Binding Lock Cylinders|Page 11978
Page 9
background image

1. Power Accessory Switch Plate.
2. Power door lock switch wiring connector:
3. Power door lock switch.

^

Carefully bend retaining tabs outward while pushing switch out of plate.

Install or Connect

1. Power door lock switch.
2. Power door lock switch wiring connector.
3. Power Accessory Switch Plate.

Trim Panel Upper Extension

Tool Required:

J 38778 Trim Panel Remover

Remove or Disconnect

1. Trim panel from the door.

A. Carefully pry the retainer from door using J 38778.
B. Pull upward to release extension from trim panel.

2. Retainer from extension.

Install or Connect

1. Retainer to extension.
2. Extension to door.

A. Insert extension on to trim panel.
B. Align retainer into hole in door. Push extension until retainer seats.

Water Deflector Replacement - Door

Front Door Trim Panel

Waterproof deflectors are used to seal the inner panel and prevent water from entering into the body. The deflector is secured by a strip of adhesive
between the deflector and door.

Remove or Disconnect

1. Trim panel.
2. Water deflector.

A. Pull the waterproof sealing tape from the deflector.
B. Break the bond between the sealer and the door with a flat-bladed tool.

Install or Connect

1. Water deflector to door.

^

Use waterproof tape or 3M(R) 777 adhesive.

2. Trim panel to the door.

Binding Lock Cylinders|Page 11980 > < Binding Lock Cylinders|Page 11978