C 2500 Truck 2WD V8-5.7L VIN R (1997)
2. Use the J 5590 in order to Install the crankshaft sprocket.
NOTE: The gears must mesh in order to prevent damage to the camshaft retainer.
3. Install the camshaft sprocket and timing chain.
4. Install camshaft sprocket bolts. Be sure to align the camshaft and the crankshaft sprocket alignment marks. Do not attempt to hammer the camshaft
sprocket. To do so may dislodge the rear camshaft plug and/or damage the camshaft.
-
Tighten the camshaft sprocket bolts to 25 Nm (18 ft. lbs.).
NOTE: Align the keyway on the reluctor ring with the key in the crankshaft and Install the reluctor ring onto the crankshaft until the ring is
completely seated against the crankshaft sprocket.
5. Install the crankshaft position sensor reluctor ring.
