C 2500 Truck 2WD V8-5.7L VIN R (1997)
51.
Install the fuel pipe (3) to the metering body. Make sure that all of the 0-rings (6 and 8), washers (7), and spacers (5) are present and in their
proper position.
52.
Install the clamp (2) and nuts (1).
Tighten
Tighten the nuts to 3 N.m (27 lb in).
53.
Apply threadlock, P/N 12345382, or equivalent to the threads of the fuel pipe bolt (4). Install the bolt.
Tighten
Tighten the fuel pipe bolt to 6 N.m (53 lb in).
54.
Install the brake booster vacuum hose and connector to the intake manifold.
55.
Install the bonnet and air inlet tube to the throttle body.
56.
Install the PCV fresh air tube to the inlet duct.
57.
Install ignition wires 1, 3, 5 (7) to the distributor cap.
58.
Add one (1) ounce of Port Fuel Injector Cleaner, P/N 12345104 (Canada P/N 10953467), to the vehicle fuel tank for each gallon of gasoline
estimated to be in the tank. Instruct the customer to add the remainder of the bottle of Port Fuel Injector Cleaner to the vehicle fuel tank at the next
fill-up. Further recommend that Port Fuel Injector Cleaner be added to the fuel tank every 3000 miles (4800 km) particularly if the vehicle is not
started and driven every day. Inform the customer that the Port Fuel Injector Cleaner is not to be used at every fill up but may be reapplied every
3000 miles (4800 km).
59.
Tighten the fuel tank filler cap.
60.
Start the vehicle and check for fuel leaks.
61.
Using the Tech 2(R) scan tool, check for any stored Powertrain DTC codes. Clear codes as required.
62.
Disconnect the Tech 2(R) Scan tool.
63.
Advise the customer to change brands of fuel.
M/L, G Van and P Truck
1.
Loosen the fuel tank filler cap to relieve fuel tank vapor pressure.
2.
Remove the engine cover.
3.
Remove ignition wires 1 3, 5, and 7 from the distributor cap.
