chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Emissions - On-Board Diagnostic System Correction|Page 317 > < Engine Controls - Bi-Fuel CNG Mass Sensor, ECM & Tank|Page 312
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Emissions - On-Board Diagnostic System Correction

File In Section: 6E - Engine Fuel & Emission 

Bulletin No.: 77-65-23

Date: November, 1997

Subject: 
On-Board Diagnostic (OBD) System Improvements 
(Re-flash Calibration)

Models: 
1997 Chevrolet and GMC C/K, P Models
with 5.7L V8 Engine (VIN R - RPO L31) and
Automatic Transmission (MT1)

with the VIN Breakpoints as shown:

While the subject vehicles have been certified as complying with the applicable U.S. Environmental Protection Agency (EPA) and California Air
Resources Board (CARB) On-Board Diagnostic (OBD) requirements, we have identified an OBD system improvement that should be implemented
whenever practical.

Condition
Engine misfire diagnostics have been inadvertently disabled.

Cause
Some vehicles were released with software which inadvertently disabled the misfire diagnostics.

Correction
Use a Tech II to verify what software is programmed into the vehicle VCM. If the improved software has not been installed, reprogram/re-flash with the
updated software. Refer to the listed table for the appropriate calibration changes.

Important

Inform customers that this work is being performed on their vehicles to improve on-board diagnostic system operation and does not affect vehicle
durability, reliability, or performance.

Calibration Information
The calibrations listed are FLASH calibrations and NOT available from GMSPO. Service FLASH calibrations are available starting with the 1997
Number 5 CD ROM.

Warranty Information
For vehicles repaired under warrant use:

Labor Operation

Labor Time 

Emissions - On-Board Diagnostic System Correction|Page 317 > < Engine Controls - Bi-Fuel CNG Mass Sensor, ECM & Tank|Page 312