C 2500 Truck 2WD V8-5.7L VIN R (1997)
Stator Installed In The Slip Ring End Frame
INSTALL OR CONNECT
1. Terminal insulator to the outside of the slip ring end frame.
2. BAT terminal to the rectifier bridge with a washer and nut.
3. Rectifier bridge into the end frame.
4. Capacitor.
-
Make sure the side with the insulator material is placed against the end frame (ground).
5. Two bolts through the rectifier bridge.
6. Two insulated screws through the rectifier bridge.
Regulator Connections
-
If the brush holder, regulator, or connector has been replaced, connect it by crimping the connectors to the other components. Solder the
connection using as little heat as possible to avoid heat damage to the regulator .
7. Brushes into the brush holder.
A. If the brushes are being reused, be sure they are clean. Wipe them with a clean, dry cloth.
B. Retract the brushes in the holder.
C. Retain the retracted brushes with a retaining pin.
D. Make sure the pin extends through the end frame when the brush holder is in place. After the rotor and drive end frame are installed, the pin
will be pulled out, allowing the brushes to contact the slip rings.
