C 2500 Truck 2WD V8-5.7L VIN R (1997)
Tool For Removing Center Support Bearing
Tool For Removing Center Support Bearing (Side View)
Tool For Removing Center Support Bearing (Installation View)
Remove or Disconnect
NOTICE: Ball bearings that are removed from the armature must be replaced with new bearings. The removal procedure causes internal damage
to the bearings.
-
Center support bearing (32) from the driveshaft (31) using a locally fabricated tool as shown in Figures 11 through 13. With the driveshaft
in a suitable support fixture, place the tool bolt ends through the access holes in the wide end of the driveshaft. Squarely press the bearing
off of the surface on the center shaft.
