chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Steering/Suspension - Wheel Alignment Specifications|Page 10244 > < Steering/Suspension - Wheel Alignment Specifications|Page 10242
Page 3
background image

26068771

Steering Gear

1

16259515

Module, EVO

1

Parts are currently available from GMSPO.

Warranty Information

For vehicles repaired under warranty, use:

Important: 

Labor operation is coded to base vehicle coverage in the warranty system.

Technical Service Bulletin # 76-30-01

Date: 970601

Alignment - Steering Wander Or Loose Steering

File In Section: 3 - Steering/Suspension

Bulletin No.: 76-30-01

Date: June, 1997

Subject: 
Steering Wander 
(Reset Alignment, Adjust/Replace Steering Gear)

Models: 
1997 Chevrolet and GMC C/K Models 
Excluding 3500 HD

Condition

An owner may comment about steering wander or the perception of loose steering at highway speeds

Correction

Follow the Strategy Based Diagnostic Steps for the condition using the Service Manual, Section 3B5, Speed Dependent Steering, Diagnosis System
Check. Perform the Front Wheel Alignment Preliminary Inspections in Section 3A-2. Verify that the front suspension "Z" dimension is within
specifications per the trim height chart on page 3A-4.

Disconnect the left and right tie rod ends and check for tight or binding ball joints and that they are properly lubricated. If all components and
specifications are correct, adjust the front wheel alignment to the following specifications.

Caster

3.80 to 3.90 degrees

Camber

0.5 degrees +/- 0.5 degrees

Sum Toe-In

.24 degrees +/- 0.2 degrees

If condition persists,

-

On vehicles below 8050 # GVW, adjust the steering gear spool valve preload and sector preload following the procedure described in Section 3B1A.

-

On Suburbans equipped with 6.5L Diesel Engine, under 8600 # GVW, built prior to March 5, 1997, replace the steering gear with P/N 26068771 and

Steering/Suspension - Wheel Alignment Specifications|Page 10244 > < Steering/Suspension - Wheel Alignment Specifications|Page 10242