C 2500 Truck 2WD V8-5.7L VIN R (1997)
corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping
force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions
can help you avoid damage to parts and systems.
Install or connect the following:
1. Relay rod to the idler arm ball stud.
2. Relay rod to the pitman arm ball stud.
a. Make sure the seal is on the stud.
b. Install J 29193 or J 29194 to ball stud.
c. Tighten Steering Linkage Installer to 62 Nm (46 ft. lbs.) to seat the tapers.
d. Remove the tool.
3. New idler arm prevailing torque nut.
4. New pitman arm prevailing torque nut. Tighten to 62 Nm (46 ft. lbs.).
5. Tie rod inner ball joints to the relay rod.
