C 2500 Truck 2WD V8-5.7L VIN R (1997)
Steering Wheel: Service and Repair
Steering Wheel Replacement
^
Tool Required:
-
J 1859-A Steering Wheel Puller
-
Or Equivalent
REMOVAL
Remove or disconnect the following:
1. Negative battery cable.
2. Disable the SIR system (if equipped).
3. Inflator module.
4. Horn contact (if equipped with SIR).
5. Horn pad assembly (if not equipped with SIR).
6. Steering wheel nut.
-
Notice the alignment mark and its relationship to the steering wheel and steering shaft.
7. Steering wheel using J 1859-A.
CAUTION: Do not hammer on the puller or damage could result to the steering column.
INSTALLATION
CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners
that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other
corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping
force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions
can help you avoid damage to parts and systems.
Install or connect the following:
