C 2500 Truck 2WD V8-5.7L VIN R (1997)
Measure
-
Tools Required:
-
J 21370-10 Gage Pin
-
J 38737 Band Apply Pin Checking Tool
1. Place J 21370-1O in the servo bore.
2. Position J 38737 over the bore with the hex nut facing the parking pawl linkage.
3. Fasten with the two rear servo cover bolts .
-
Tighten bolts to 24 Nm (18 ft. lbs.).
4. Ensure J 21370-10 moves freely in the tool and pin bore.
5. To determine the correct pin length, apply torque to the nut on the gage.
-
Tighten nut to 34 Nm (25 ft. lbs.).
