C 2500 Truck 2WD V8-5.7L VIN R (1997)
Shift Cable: Adjustments
4L60-E
Adjust
1. Ensure that transmission shift lever is in the mechanical park position.
-
The transmission control lever can be positioned to mechanical park by rotating the control lever clockwise until it reaches it's final stop
position.
-
Apply parking brake
-
Raise and support the vehicle.
2. Slide the black retaining clip forward on the shift cable end far enough to allow the white lock button to be pushed out.
3. Push the white lock button on the shift cable end "OUT" far enough to free the metal core adjust body inside the cable end.
-
Do not push the white lock button completely out.
4. Inspect the metal core adjust body on the shift cable end for dirt or debris that may restrict its travel. If dirt or debris is found, remove it by
washing the shift cable end, metal core adjust body, and white lock button with soap and water. If after cleaning, the travel of the metal core adjust
body remains restricted, the shift cable assembly must be replaced.
-
Lower the vehicle.
-
Ensure that the parking brake is applied.
5. Turn the ignition switch to the "ON" position.
6. Move the transmission shift lever from "P" (Park) to "1" (One) and back to "P" (Park) ten times.
7. Place the shift lever to the "P" (Park) position.
8. Turn the ignition switch to the "OFF" position.
-
Raise and support the vehicle.
9. Ensure that the transmission control lever is in mechanical park by rotating the control lever clockwise until it reaches its full clockwise stop
position.
10. Push the white lock button "IN" to secure the core adjuster body inside the shift cable end.
11. Slide the black retainer clip rearward over the shift cable end until it covers the white lock button and locks in place over the shift cable end.
-
Lower the vehicle.
-
Ensure that parking brake is applied.
