C 2500 Truck 2WD V8-5.7L VIN R (1997)
REMOVE OR DISCONNECT
-
Ensure that the shift lever is positioned into the mechanical 3rd or 4th gear prior to removal of the shift housing from the transmission. The
transmission must remain in this state when the shift housing is removed.
-
Do not disassemble the transmission shift housing. Internal parts for this shift housing are not available. Opening the shift housing voids the
warranty.
-
When removing the shift housing from the transmission, use the exposed bolts on the base of the housing. Do not use the bolts under the rubber
boot located at the top of the housing.
1. Shift lever and boot.
2. Four bolts securing the shift housing to the transmission.
3. Insulator from the transmission case.
INSTALL OR CONNECT
1. Insulator to the transmission case.
2. Four bolts securing the shift housing to the transmission.
-
Tighten shift housing bolts to 15 Nm (11 ft. lbs.).
3. Shift lever and boot.
