C 2500 Truck 2WD V8-5.7L VIN R (1997)
Door Hardware Lubrication
The mechanical components of the door assembly are lubricated during assembly If additional lubrication is required to any door hardware mechanism
use Lubriplate Spray-Lube "A" GM P/N 1052349, Lubriplate Auto-Lube "A" GM P/N 1052196, or equivalent. Lubricate door hinge pins and
rollers at normal service intervals with 30 weight engine oil. Do not lubricate hinge roller to hold-open link contacting surfaces. This may prevent the
roller from rolling properly.
Inside Door Handle
Front Door Inner Handle Assembly
Tool Required:
J 34940 Rivet Gun
Remove or Disconnect
1. Trim panel.
2. Water deflector.
3. Inside door handle assembly.
^
Drill out the rivet head using a 5-mm (3/16-inch) drill bit.
^
Slide door Handle forward.
4. Control rods from the handle and lock lever.
Install or Connect
1. Control rods to handle and lock lever.
2. Inside door handle.
^
Insert handle assembly into slot and slide assembly to the rear.
^
Handle rivet using J 34940.
3. Water deflector.
4. Trim Panel.
Inner Mounting Panel Assembly
Remove or Disconnect
^
Lower Window
1. Trim panel.
2. Water deflector.
3. Speaker (if equipped)
^
Carefully pry out retainer clips.
