C 2500 Truck 2WD V8-6.0L VIN U (2002)
13. Remove the bolts and the yoke retainers from the transmission pinion yoke, w/ RPO MW3 or M74.
14. Remove the front propeller shaft by disconnecting the front propeller shaft from the transmission pinion yoke, w/ RPO MW3 or M74.
Installation Procedure
1. Install the front propeller shaft by sliding the front propeller shaft into the transmission or the transfer case, w/o RPO MW3 or M74.
2. Install the front propeller shaft to the transmission pinion yoke, w/ RPO MW3 or M74.
Important:
^
Align the reference marks made during removal.
^
Tighten the bolts until snug. Do not torque the bolts at this time.
3. Install the yoke retainers and the bolts, w/ RPO MW3 or M74.