C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
14. Align the hinge and install using fasteners supplied.
NOTE: Refer to Fastener Notice in Service Precautions.
15. Install the hinge bolts.
Tighten
Torque the hinge bolts to 25 N.m (18 lb ft).
IMPORTANT:
^
If installing the original access door without a door side service hinge or a used access door, you must modify the door side of the hinge (1) lower
extensions (2).
^
Hinge extensions must maintain a wall thickness of 2 mm between the end of the extensions and the body side hinge nuts (3).
^
Maintain a wall thickness of 2 mm (5/64 in) around the hole at the end of the extension (4).
^
Prior to refinishing, refer to publication GM 4901 M-D-2000 GM Approved Refinish Materials for recommended products. Do not combine paint
systems. Refer to paint manufacturer's recommendations.
16. Clean and prepare all surfaces.
17. Refinish as necessary.
18. Install and align all related panels and components.
Rear Door Hinge Replacement
Rear Door Hinge Replacement
Removal Procedure