C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
Notice: Refer to Fastener Notice in Service Precautions.
3. Loose assemble the bottom 2 bolts.
1. Close door to self adjust latch assembly.
Tighten bolts to 9 N.m (80 lb in).
2. Open the door.
3. Install the upper bolt.
Tighten the bolt to 9 N.m (80 lb in).
4. Install the door trim panel.
Rear Door Latch Control Replacement
Rear Door Latch Control Replacement
Removal Procedure
1. Remove the rear door trim panel, as necessary.
2. Pull back the water deflector, as necessary. Refer to Water Deflector Replacement.
3. Disconnect the lower latch cable from the handle.
4. Remove the latch control handle screws.
5. Remove the latch control handle.
6. Disconnect the upper latch cable from the handle.
Installation Procedure
1. Connect the upper latch cable.
2. Install the latch control handle.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the latch control handle screws.
Tighten the screws to 9 N.m (80 lb in).