C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Remove and discard the 2 O-rings.
Installation Procedure
1. Install 2 NEW O-rings on the oil level indicator tube.
2. Lightly lubricate the O-rings with engine oil.
3. Install the oil level indicator tube to the engine.
4. Install the right exhaust manifold.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the bolt holding the oil level indicator tube and the fuel injection control module bracket.
^
Tighten the oil level indicator tube bolt to 21 Nm (15 ft. lbs.).
6. Install the oil level indicator.
7. Install the heater outlet hose bracket nut (1) and bolt (2).
^
Tighten the hose bracket nut to 9 Nm (80 inch lbs.).
^
Tighten the hose bracket bolt to 25 Nm (18 ft. lbs.).
