C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Install the suction hose to the vehicle using new sealing washers.
2. Connect the suction hose to the accumulator.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the NEW compressor suction hose nut at the accumulator.
Tighten
Tighten the nut to 16 N.m (12 lb ft).
4. Connect the suction hose to the compressor (1).
5. Install the NEW suction hose mounting bolt (3).
Tighten
Tighten the bolt to 16 N.m (12 lb ft).
6. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
7. Leak test the fittings of the component using the J 39400-A.
A/C Discharge Hose/Line
DISCHARGE HOSE REPLACEMENT (W/ DENSO)
TOOLS REQUIRED
J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE