C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Disconnect the electronic brake control module mounting bracket (3) from the frame rail (5).
10. Allow the electronic brake control module to remain loose in order to allow fuel pipe clearance.
11. Remove the fuel bundle using the following procedure:
11.1. Guide the fuel bundle (2) pipes towards the rear of vehicle to clear the engine.
11.2. Lower the fuel bundle while moving it foreword and out.
INSTALLATION PROCEDURE
1. Install the fuel pipe bundle using the following procedure
1.1. Install the fuel bundle to the chassis by guiding the pipes towards the rear of vehicle.
1.2. Lift the fuel pipes, while guiding the forward portion of the pipes up towards the engine connections.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Attach the fuel bundle to the chassis.
Tighten
Tighten the fuel bundle retaining nuts (1) to 16 N.m (12 lb ft).
