C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
2. Install the piston seal being careful not to twist the seal in the caliper bore.
3. Install the boot on J24548.
3.1.
Place the large diameter of the boot over the tool, then carefully work the smaller diameter onto the tool.
3.2.
Slide the large diameter of the boot off the tool.
4. Install the boot in the caliper bore groove. The lip of the boot must firmly sit in the groove.
5. Install the piston inside J24548.
6. Install the piston halfway into the bore.
7. Remove J24548. Make sure that the boot is sitting firmly in the groove.
Notice: Refer to Fastener Notice in Service Precautions.
