C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
2. Install the combination valve (11) onto the BPMV (3).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the three Allen bolts (10) that fasten the combination valve (11) to the BPMV (3).
Tighten the three Allen bolts to 8 Nm (6 ft. lbs.), then to 16 Nm (12 ft. lbs.).
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
4. Install EBCM (2) onto BPMV (3).
Important: Do not reuse the old mounting bolts. Always install new bolts with the new EBCM.
5. Install the four EBCM bolts (1).
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X-pattern.
6. Install BPMV (4) to bracket (6).
7. Install the three BPMV to bracket retaining bolts (8).
Tighten the three bolts to 9 Nm (7 ft. lbs.).
8. Connect the four electrical connectors to the EBCM (2).
9. Install the EHCU and bracket to the vehicle.
10. Install the EHCU bracket to vehicle mounting bracket bolts.
Tighten the bolts to 12 Nm (9 ft. lbs.).
11. Install the right front, left front and rear brake pipes to the tube adapters (5).
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
12. Install the front and rear brake pipes (from master cylinder) to the combination valve (11).
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
13. Connect the electrical connector (9) to the combination valve (11).
Important: Verify that the combination valve metering rod is depressed during bleeding.
14. Bleed the hydraulic brake system.
15. Return to Diagnostic System Check-ABS.
