C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Tail Lamp: Service and Repair
TAIL/TURN SIGNAL LAMP REPLACEMENT (CAB/CHASSIS)
REMOVAL PROCEDURE
1. Disconnect the lamp electrical connector from the lamp assembly.
2. Remove the nuts from the back of the bracket.
3. Remove the lamp assembly from the bracket.
4. Remove the 4 lens screws.
5. Remove the lens.
6. Remove the gasket.
7. Remove the bulb.
INSTALLATION PROCEDURE
1. Install the lamp assembly to the bracket.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the nuts to the back of the bracket.
Tighten
Tighten the nuts to 35 N.m (26 lb ft).
3. Connect the electrical connector to the lamp assembly.
4. Install the bulb.
5. Install the gasket.
