C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Turn Signal Lamp: Service and Repair
Park/Turn Signal Lamp Replacement (Base with Composite)
REMOVAL PROCEDURE
1. Make sure the headlamp switch is in the OFF position.
2. Remove the screws.
3. Remove the park/turn signal lamp assembly.
4. Disconnect the electrical connector.
5. Remove the bulbs from the assembly.
INSTALLATION PROCEDURE
1. Install the bulbs to the park/turn signal lamp assembly.
2. Install the lamp assembly.
3. Connect the park/turn signal lamp connector.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screws.
Tighten
Tighten the screws to 2 N.m (18 lb in).
