C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Fuel Shut-off Solenoid: Service and Repair
Engine Shutdown Solenoid Replacement
Engine Shutdown Solenoid Replacement
REMOVAL PROCEDURE
1. Remove the electrical connector from the engine shut-down (ESO) solenoid.
2. Use compressed air in order to blow any dirt away from the ESO solenoid.
3. Remove the ESO solenoid.
INSTALLATION PROCEDURE
1. Install the new O-ring on the ESO solenoid.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
2. Install the ESO solenoid in the injection pump.
Tighten
Tighten the solenoid (external hex or internal hex) to 25 N.m (18 lb ft).
3. Install the ESO electrical connector.
4. Start the engine and check for leaks.
