C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Transmission Position Switch/Sensor: Adjustments
Park/Neutral Position Switch Adjustment Adjustment Procedure
Important:
^
Apply the parking brake.
^
The engine must start in the P (Park) or N (Neutral) positions only.
^
Check the switch for proper operation. If adjustment is required, proceed as follows:
1. Place the transmission range selector in the N (Neutral) position.
2. With an assistant in the drivers seat, raise the vehicle. Refer to Vehicle Lifting.
3. Loosen the park/neutral position switch mounting bolts.
4. With the vehicle in the N (Neutral) position, rotate the switch while the assistant attempts to start the engine.
5. Following a successful start, turn the engine off.
Notice: Refer to Fastener Notice in Service Precautions.
6. Tighten the bolts securing the switch to the transmission.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
7. Lower the vehicle.
8. Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only.
9. Replace the park/neutral position switch if proper operation can not be achieved.
