C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
1. Lube the new O-ring with engine oil.
IMPORTANT: A new TDC Offset must be learned after replacing a crankshaft position sensor. Refer to Fuel Injection Pump TDC Offset
Adjustment.
2. Install the sensor in the engine.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the sensor mounting bolt.
Tighten
Tighten the mounting bolt to 25 N.m (18 lb ft).
4. Install the sensor electrical connector.
5. Install the power steering pump.
6. Install the negative battery cables.
