C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Oil Pressure Sensor: Service and Repair
ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT
TOOLS REQUIRED
J 41712 Oil Pressure Sending Unit Socket
REMOVAL PROCEDURE
1. Remove the engine cover from the engine block.
2. Remove the fuel filter/water separator from the lower intake manifold and position to the side.
3. Remove the electrical connector from the oil pressure sending unit.
4. Use the J 41712 to remove the oil pressure sending unit from the engine block.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.